Publicidad
Idiomas disponibles
Idiomas disponibles
5. CONTROL PANEL
1
Error indicator. See description of errors in this instruction manual.
2
Overheating indicator - When switched on, the entire welding service and the interface will be
blocked.
3
Machine on and under voltage indicator
4
Gas test button - to manually advance the wire without consuming gas and energy.
5
Wire test button - To purge the gas pipe from the gun and allow the flow to be adjusted on the flow
meter.
6
Welding current display y of the values set with button 11.
7
Electronic inductance adjustment LED - less inductance (narrower arc, more penetration) and more
inductance (wider arc, more filling)
8
Wire speed adjustment LED
9
HOLD LED - Display of welding voltage and current values after welding for 2 seconds on the
respective displays
10
LED for selecting the MIG/MAG welding current on the corresponding display and for adjusting the
LIFTIG welding current and MMA welding current.
11
Inductance / Wire speed selector / HOLD function / Welding current display and knob for adjusting
Inductance, Wire speed and MMA and TIG welding current parameters
12
Welding mode selector: MIG/MAG 2T welding (when the MIG/MAG and 2T LEDs are lit), MIG/MAG
4T welding ( when the MIG/MAG and 4T LEDs are lit), MIG/MAG SPOT welding ( when the MIG/MAG
and SPOT LEDs are lit), MIG/MAG MECAPULSE 2T welding ( when the MIG/MAG, 2T and
MECAPULSE LEDs are lit), MIG/MAG MECAPULSE 4T welding (when the MIG/MAG, 4T and
MECAPULSE LEDs are lit), TIG 2T welding (when the TIG and 2T LEDs are lit), TIG 4T welding
(when the TIG and 4T LEDs are lit), MMA welding and ARCO AIRE cutting and chamfering (when the
ARC AIR LED is lit).
13
When in MECAPULSE mode, it allows the speed of the wire motor to be set between two values
STOPPED and FORWARD for the time selected with button 17.
14
Display of welding voltage and the values set with button 17.
15
Memory selection and storage indicator (MEM).
16
Welding cycles (setting welding parameters)
17
Button for adjusting welding voltage and welding parameters.
Fig. 1
10
Publicidad
