Setting The Extract Fan Speed - AERMEC RePuro 100 Manual De Instrucciones

11.6.

SETTING THE EXTRACT FAN SPEED

During manual mode the extract fan speed is activated at the speed set by parameter PO2. This parameter can be set varying
from the minimum speed up to the maximum speed, with 20 intermediate control steps (to match air flow / step, see technical
manual).
To set this parameter it is necessary to see the "extract fan menu" (accessed through the procedure detailed in paragraph 11.4),
by pressing the key MODE/SELECT to enter into modification mode (such a mode is shown by the flashing of the fan icon) and
entering the desired value using the navigation keys and confirming the value by pressing the MODE/SELECT key again.
1
Flashing of this icon shows that the modi-
fication mode of the fan speed is active
2
Each press of the navigation keys increas-
es or decreases the extract fan speed
3
After having confirmed the value the extract fan operates at
the speed set for this parameter during MANUAL mode opera-
tion
32
4238010_02 - 1302
Extract fan menu:
1
Activate fan modification
mode
2
Set fan speed
3
Confirm fan speed