Ametek SURGEX AXESS Ready FLATPAK SA-82-AR Guía De Instalación Del Hardware página 27

Idiomas disponibles

________________________________________________________________________________________________

III. Introduction

The SurgeX ® SA-82-AR is a network attached, IP addressed, web-controlled AC surge protector and power

conditioner. The SA-82-AR may be used to switch up to 8A at 120V. The simple web server structure allows

basic control of two outlets. The extensive programming and setup capabilities are accessed by a web browser,

through a Device Management Utility (DMU), or through a Command Line Interface (CLI).

•

The SA-82-AR features SurgeX

Tolerant EMI/RFI filtering and Over-Voltage Shutdown.

•

Remote reboot any device: monitors, routers, servers, kiosks, etc. The remote device need not be

network attached.

•

Conserve energy by powering down equipment when not in use.

•

Telnet access uses the Command Line Interface (CLI) structure and syntax to completely configure and

control the SA-82-AR. This Axess Ready (AR) device also supports the DxP protocol, which allows

software developers to integrate the unit into custom applications.

•

Up to 2 systems can be continuously monitored with AutoPing,with automatic power control upon loss

of contact. Reboot crashed systems or provide auto power-up, or - down for environmental controls and

notification systems.

•

The SA-82-AR utilizes 2 levels of password security, with only the administrative account having access to

setup and configuration.

Located on the rear panel are the input IEC power plug, network connection (RJ-45), 8A circuit breaker, and output

receptacles.

The front panel contains the Outlet On LED, Self-Test LED, System On LED, and Reset button.

SA-82-AR

Series Mode

surge protection, Impedance

Manual del usuario