Publicidad
Idiomas disponibles
Idiomas disponibles
________________________________________________________________________________________________
3. Setup Pages
Setup pages are only available while logged in with Administrator credentials. Press Save to save the new settings.
If the new settings require the AR to be rebooted, a Reboot button will appear at the bottom of the page. Settings
requiring reboot will not take effect until the unit is rebooted.
Device
Location ID: Specifies a name label (up to 20 characters) that will be displayed at the top of all pages.
Assigning unique names is helpful for management of multiple units.
Cycle Time: Specifies the length in seconds of a power cycle (1-999 seconds). This is the amount of time
the outlet will temporarily be On or Off, depending on the initial outlet state.
Disable Off: When checked, removes the Power OFF button from the Status and Control page.
Initial State: Specifies the initial state the AC outlet(s) will assume when the unit is powered up or reset.
Upgrade Enable: Enables the ability to upgrade the firmware of the AR.
Auto Logout: Specifies the inactivity timer duration in minutes (0-99 minutes). If there is no activity after the
specified amount of time, the user will be automatically logged out. Setting the timer duration to 0 disables the
timeout feature.
Enable Security Timeout: When unchecked, disables the 2 minute window for setting IP address and factory
defaults via DMU.
Important: As the AR allows only one web user logged in at any time, use caution when
disabling the timeout feature, as it is possible to lock out other users by forgetting to log
out. Closing the web browser will not log the user out, and may lock out web access. In this
situation it will be necessary to access the AR via telnet and reboot the unit.
© AMETEK Electronic Systems Protection, Inc. | Soporte técnico: 800-645-9721 | surgex.com
SA-82-AR
Manual del usuario
32
Publicidad
