Ametek SURGEX AXESS Ready FLATPAK SA-82-AR Guía De Instalación Del Hardware página 30

Idiomas disponibles

________________________________________________________________________________________________

Manage

Open Browser: Opens the web browser interface for the selected AR.

Upgrade Firmware: Starts the Firmware Upgrade dialogue. Firmware

Upgrade requirements: Valid firmware

Set

IP Address: Changes the IP address of the selected AR.

Factory Defaults: Return the selected AR to a Factory Default state. This action must be

performed within the first 2 minutes after powering up the unit.

Local Address: Select the IP address to Discover on. This may be necessary for computers with

multiple network connections.

Exit

Exits the DMU program.

Help

Online Help: Opens a web browser to online help resources.

About: Displays DMU version information.

2. Setting the IP Address

ARs are configured with a DHCP assigned factory default IP address.

To set the AR's IP address using one of the following methods, the computer and AR must be on the same local

network.

DMU: Follow the steps in the preceding subsection to set the IP address using the

Device Management Utility (DMU).

CLI: These are the basic commands to set the network parameters. After setting these parameters, the AR

will need to be rebooted for the settings to take effect. Any command that requires rebooting of the AR

will provide a prompt to do so. All commands may be entered as required before rebooting. Manually specifying

the IP address via CLI automatically sets the address as static.

file. Administrative login

credentials.

"Upgrade Enable" must be set to yes, set via web page or CLI.

SA-82-AR

Manual del usuario