Publicidad
Idiomas disponibles
Idiomas disponibles
________________________________________________________________________________________________
The CLI command set ipmode dhcp followed by a reboot command may be used to configure the AR to
automatically acquire its network settings from a DHCP server. A DHCP server will automatically assign
an IP address (dynamic address), as well as the Subnet Mask and Gateway.
To determine what IP address has been automatically assigned by the DHCP server, you will need to
use the Discover feature of the DMU or query your DHCP server and locate the MAC address of the AR in
the DHCP server's IP/MAC table.
Web: To set the IP address using a web browser, navigate to the current IP address of the AR. Enter the
administrator credentials (Factory Default User: admin, Password: admin), click on "Setup", then click on
"Network" and follow the directions in the Web Server/Network/Setup section of this manual.
IV. Outlet On LED Indicator
The Outlet On LED functionality is as follows:
LED State
Description
On (Solid)
The outlets are On.
On (Blinking)
The Reset button has been pressed for 5 or more seconds. Releasing the button will
restore the AR to a factory default state.
Off
The outlets are Off.
© AMETEK Electronic Systems Protection, Inc. | Soporte técnico: 800-645-9721 | surgex.com
Example: Telnet to IP address of 192.168.1.254 on default Port 23:
SurgeX Axess Ready v1.01.41
User> admin
Password> *****
Axess Ready> set ipaddress 10.1.2.69
Ok
Axess Ready Reboot Required> set subnet 255.255.255.0
Ok
Axess Ready Reboot Required> set gateway 10.1.2.1
Ok
Axess Ready Reboot Required> reboot
SA-82-AR
Manual del usuario
30
Publicidad
