Changing The Protection Grid On The Bottom - Vorwerk Thermomix TM5 Manual De Instrucciones

CHaNGING THE PROTECTION GRID

Changing the protection grid on the bottom

To install the protection grid on the bottom of the Thermomix
the Thermomix from the mains power supply. Remove the mixing bowl and
®
tilt the Thermomix as shown 1 . Take the protection grid for the bottom 2 .
®
It has an oval bump that must face the bottom of the Thermomix
Lay the protection grid under the upper ridges, then press down until you hear
that the grid has locked in place 4 .
To remove the protection grid, disconnect the Thermomix
power supply first. Remove the mixing bowl and tilt the Thermomix
the same way as when you inserted the grid. There is a tab at the left of the
protection grid. Pull on this to remove the protection grid.
1
4
50 Changing the protection grid
, disconnect
®
®
from the mains
®
2
3 .
in
®
3