Alpinestars Tech-Air 3 Canvas Manual De Instrucciones página 46

18. Troubleshooting
Problem
LED Display (2) does not
switch on when Activation
Zip (1) is closed
SOLID red LED on the LED
Display (2)
Flashing red LED, while blue
LED is on
Possible Cause
System Battery fully discharged
LED Display (2) not properly
connected to the Electronic
Control Unit (3)
Gas inflator empty and/or
Airbag must be replaced
System Error
Battery Low
Possible Solutions
Recharge battery (see Section 11) and check
the correct LED behavior during the recharge.
Check the correct insertion of the cables.
After a deployment, the gas inflator must be
replaced. Until such replacing, the System
will not work even though the battery is
charged and the LED Display (2) will show the
red light until the gas inflator is replaced.
If the same Airbag has deployed more than
3 times, the red LED will indicate a System
fault even after the replacement of the gas
inflator. In this case, the Airbag itself must
be replaced and the System reactivated by an
Authorized Tech-Air® Service Centre.
If gas inflator is not empty (double check this
using the Tech-Air® App), the System may
have an internal error. Contact an Authorized
Alpinestars' Tech-Air® Service Centre to
check the System.
Remaining battery level is lower than 4 hours.
Recharge the battery as soon as possible.
47 EN