Alpinestars Tech-Air 3 Canvas Manual De Instrucciones página 51

Level of Performance and Mechanical Requirements for each Protection Class
The Technical Standard EN 17092:2020 requires that motorcycle protective garments have
to fulfill with mechanical requirements according to the relevant class of protection set
forth by the Technical Standard EN 17092:2020.
The following requirements are established for the most exposed areas (i.e. shoulders,
elbows, hips, knees) as follows:
Class AAA
garments
TEST
EN 17092-
PERFORMED
2:2020
Impact 120 km/h – 75
abrasion mph
resistance
Tear strength 50 N
Seam strength 12 N/mm
Motorcyclists' back protectors
The Tech-Air®3 Canvas System is compatible with the removable passive back protectors
listed below. A passive back protector provides protection to the back area even if the
System does not deploy. These back protectors are certified as a Personal Protective
Equipment Category II, under the Regulation EU 2016/425, according to the EN 1621-
2:2014 standard. These products are in compliance also under the corresponding UK
legislation (Regulation 2016/425 on Personal Protective Equipment as applied in GB).
52 EN
CLASS OF PROTECTION
Class AA Class A
garments garments
EN 17092- EN 17092-
3:2020 4:2020
70 km/h – 45 km/h –
43 mph 28 mph
40 N 35 N
8 N/mm 6 N/mm
Class B Class C
garments overgarment
EN 17092- garments
5:2020 EN 17092-
6:2020
45 km/h – 45 km/h –
28 mph 28 mph
35 N 35 N
6 N/mm 6 N/mm
Class C
undergarment
garments
EN 17092-
6:2020
Not applicable
10 N
4 N/mm