Publicidad
Unit
3 - Lightly grease the lower bearing seat and slide
pcs
the compression cup (12) onto the steerer tube until
it reaches the upper bearing.
pcs
set
4 - Slide the junction spacer (10) onto the steerer
pcs
tube until it reaches the compression cup (12).
pcs
5 - Insert as many 5mm (8) or 10mm (9) riser
1
spacers as required, taking care to thread the hoses
through and without exceeding a maximum rise of
pcs
50mm.
pcs
6 - Slide the dedicated under-stem cable guide (7)
22
pcs
with the cables inside.
pcs
23
7 - Degrease the dedicated stem and install it by
pcs
applying firm pressure to overcome the stiffness of
24
pcs
the hoses and bend them to follow the curve in the
stem.
pcs
25
pcs
8 - Check that the specific stem bolts are in place
26
(4).
pcs
pcs
27
9 - Insert the expander plug (3) and tighten to a
pcs
torque of 8Nm, making sure that the steerer tube is
cut to 5mm below the upper surface of the stem. The
28
pcs
expander plug will then cover 2mm, leaving 3mm for
the compression of the headset.
pcs
29
pcs
10 - Insert the screw (2) and the cap (3), then tighten
until there is no more play in the headset, without
pcs
exceeding 2 Nm.
pcs
pcs
11 - Align and tighten the stem bolts to a maximum
torque of 5Nm.
pcs
pcs
12 - Note that the frame is not compatible with a
stem other than the LOOK LS3 model.
pcs
pcs
pcs
pcs
pcs
29
30
15
Volume (mm3)
Drawn by
rhuang
16
17
18
19
15
31
20
21
No.9 quantity from 4pcs->8pcs
Modification
SCALE 1:4
Mass (g)
SHEET A2
Date
31-10-2022
1
2
3
4
5
6
4
15
Material
ASSEMBLY
CD-RT45(765 OPT2)
PART
FR
7
8
9
10
11
12
13
14
RH
30/11/2022
01
Resp
Date
Ind.
Treatment
REFERENCE
18
Publicidad
