Publicidad
Idiomas disponibles
Idiomas disponibles
WORKING
SL TC Model – Glass (fig. 14)
A : ON/OFF lights
B : speed reduction / OFF motor
C : speed indicators
D : ON motor/speed increase
E : 10 min timer.
The Touch control panel on the glass allows
you to set the function desired by lightly tou-
ching the corresponding key.
If the electrical power supply to the SLTC mo-
del is cut, 15 seconds are needed for self-
diagnostic after its functions are restored. In
the meanwhile, its operation may be incor-
rect.
SLTR Model (fig. 15)
The rotary knob (fig. 15A) allows you to select
the various functions of the appliance.
All the indicators (fig. 15B) are always lit in
the stand-by function ; functions are selected
sequentially by turning the knob ; the desired
function is set by pressing the knob.
- LIGHTS Indicator (fig. 15C)
This function allows you to switch the lights
on or off; turn the rotary control until the
function is selected, then set it by pressing
the rotary control.
- Timer Indicator (fig. 15D)
By setting this control, at any speed, the ap-
pliance will be switched off after 10 minutes.
It is necessary to select the control again in
order to exit from this function. . When the.
Timer function is set , the Timer indicator will
flash and the corresponding speed indicator
is lit.
- Speed Indicators (fig. 15E)
They are lit accordingly to the speed set.
OFF Indicator (Fig.15 F): This function allows
you to completely switch off the motor; it is
totally lit during selection and setting, while
it is in stand-by afterwards.
SLTR75, SLTC75 Model
The SLTR75, SLTC75 model, in addition to the
working features described in the paragraph
above, has an automatic opening and closing
system of the glass panel.
The opening of the glass panel corresponds
to and varies according to the motor speed
set.
The panel is closed automatically, after the
motor is switched off.
A safety device reverses the panel direction in
case of impact with unusual surfaces during
its normal travel.
All of the appliances are equipped with an
electronic device allowing for automatic
switching off after four hour working from
the last operation performed.
The electric red button on the upper side of
the hood allows to reset the appliance when
there is an operation anomaly.
Press the red button to power off the hood
and then press again the red button to resto-
re power on.
Controls (Fig. 16) - SL
The appliance allows you to set three motor
speeds.
When the slider is placed on the left the
appliance is OFF; by moving the slider
rightwards it will be possible to increase the
motor speed.
Lighting is turned ON and OFF by pushing the
related button.
TIMING
As a result of the new EU65 "Energy label" and
EU66 " Ecodesign" regulations issued by the
European Commission, which came into force
as from January 1st, 2015 , our products have
been adapted to comply with these new re-
quirements.
All of the models complying with the energy
label requirements, are equipped with new
electronics including a timer device for suc-
tion speeds control, when the air capacity ex-
ceeds 650m³/h.
Internal motor models, with maximum air
capacity higher than 650m³/h, are equip-
ped with a timer device that automatically
switches the suction speed from 4th to 3rd
speed, after 5 minutes operation.
External motor models are equipped with
remote motors that , as for internal motor
versions, include a timer device that switches
down the suction speed when it exceeds 650
mᵌ/h. (See External Motors Instructions ).
14
Publicidad
