Sirius SLTR75 2013 Instrucciones De Uso Y De Montaje página 15

Remote motors, whose air capacity exceeds
650m³/h at both 4th and 3rd speed , will
have the following by default timer control
functions: The suction speed is automatically
switched from 4th to 2nd speed, after 6 mi-
nutes operation.
If the appliance is working at 3rd speed, it is
automatically switched to 2nd speed, after 7
minutes operation. Operation speeds can
also be changed during operation.
The energy consumption of the appliance in
stand – by mode is lower than 0.5W.
MAINTENANCE
An accurate maintenance guarantees good
functioning and long-lasting performance.
Particular care is due to the grease filter.
It can be removed by following the instruc-
tions below:
SLTR75 - SLTC75:
Open the front glass panel by selecting the
maximum speed, remove the steel grid by
pulling it outwards (fig. 8), then act on the
filter handle and rotate it outwards.
SL90 – SL91:
Open the front glass panel, by acting on its
handle and rotate it outwards.
Grease filters are inserted by following the
reverse procedure.
SLTR75 – SLTC75 models only
After 30 hour working, the grease filter satu-
ration will be signaled by the simultaneous
lighting of speed indicators; select the timer
function with the hood off to reset it.
The grease filter needs cleaning by regular
hand-washing or in dishwashers, every two
months at least, or depending on its use.
* If the appliance is used in the filtering ver-
sion, the activated charcoal filter needs to be
replaced periodically.
The charcoal filter is removed by removing
the grease filter first, following the instruc-
tions above, then by pulling its special plastic
tongue until it is released from its seat.
The charcoal filter is inserted by following the
reverse procedure.
Tepid water and neutral detergents are re-
commended to clean the appliance, while
abrasive products should be avoided.
The power cord shall be replaced by au-
thorized personnel only.
Substitution of the LED bar:
Using an appropriate tool, remove the LED
bar from its seat (refer to fig. 17), disconnect
it electronically using the appropriate con-
nector then substitute it with a LED bar with
same characteristics.
15