Publicidad
Idiomas disponibles
Idiomas disponibles
2.4.4 Choosing an operating mode
The operating mode can be adjusted depending the heating/cooling need for the pool, see "2.2.1 Mode details" for
more details about operating modes. To change the operating mode :
• Unlock the keypad: the main menu is displayed.
• Press
to change the operating mode :
• Press
to browse through the available modes.
• Press
to validate one operating mode and return to the main menu.
• Press
for 2 seconds to activates the compressor and start heating/cooling.
2.4.5 Adjusting the temperature setpoint
• Unlock the keypad : the main menu is displayed.
• Check that the compressor is working : the
and "2.2.1 Mode details" to choose an operating mode and activate the compressor.
is displayed. Press
• SET
• When the setpoint temperature is exceeded by 1°C, the heat pump stops heating/cooling the water.
Then, the heat pump automatically regulates the pool water temperature (independant to the chosen
mode).
• The heat pump runs again to reach out the setpoint when there is a gap of 1°C between the pool water
temperature and the setpoint water temperature.
• Example: the setpoint temperature is 25°C and the pool water temperature has reached 26°C in heating
or cooling mode. The heat pump stops.
- In cooling mode, the appliance will automatically run again if the pool water temperature is higher
than 26°C.
- In heating mode, the appliance will automatically run again if the pool water temperature is lower
than 24°C.
• If heating priority is not activated, the heat pump waits for the next filtration pump cycle to run.
2.4.6 Deactivating the operation of the heat pump
It may be necessary to deactivate the operation of the heat pump, for maintenance purposes for example. In this case,
the user interface (screen) remains powered. To deactivate the operation of the heat pump :
• Unlock the keypad: the main menu is displayed.
• Press
for 2 seconds. The heat pump's compressor will stop after few minutes : the
the compressor isn't working.
• Make sure to switch the compressor on again by pressing
the heat pump.
The heat pump may take up to 5 minutes to restart after the starting it back up.
appears.
icon must be displayed, see "2.4.4 Choosing an operating mode"
and
to modify the temperature setpoint.
for 2 seconds to guarantee the normal operation of
EN
icon disappears when
16
Publicidad
