Eaton TRIPP LITE Serie Manual Del Propietário página 4

Standard Installation
In a standard installation, there is only one splitter being used to connect two
(B116-002A and B116-002A-INT) or up to four (B116-004A) sets of monitors and
speakers. The following rules apply to a standard installation:
• The distance between the source and the splitter must not exceed 16 ft. (5 m).
• For source video resolutions anywhere from 1600 x 1200 @ 60 Hz to
1920 x 1200 @ 60 Hz. The distance between the splitter and the connected
monitor and speakers must not exceed 49 ft. (15 m). The video distance can be
extended by using a B120-000 DVI extender. The B120-000 can be located up to
65 ft. (20 m) from the splitter and 16 ft. (5 m) from the connected monitor.
• For source video resolutions lower than 1600 x 1200 @ 60 Hz. The distance
between the splitter and the connected monitor and speakers must not exceed
65 ft. (20 m). The video distance can be extended by using a B120-000 DVI
extender. The B120-000 can be located up to 114 ft. (35 m) from the splitter and
16 ft. (5 m) from the connected monitor.
• The B116-002A, B116-002A-INT and B116-004A are designed for monitor
refresh rates of 60 Hz.
Adapter
1. Make sure the DVI and Audio source is powered OFF.
2. Connect the DVI and Audio source to the input ports on the splitter using a DVI
with 3.5 mm Audio Cable (P560-XXX-A Series), or a Single-Link DVI Cable
(P561-Series) and 3.5 mm Audio cable (P312-Series).
4
DVI/Audio Source
Output 3 Output 4 Output 1 Output 2