Eaton TRIPP LITE Serie Manual Del Propietário página 5

Standard Installation
3. Connect a monitor and speakers to a set of available output ports on the splitter
using a DVI with 3.5 mm Audio Cable (P560-XXX-A Series) or a Single-Link DVI
Cable (P561-Series) and 3.5 mm Audio cable (P312-Series).
4. Repeat step 3 for each additional set of monitor and speakers you are
connecting to the splitter.
5. Connect the included external power supply to the splitter and plug it into a
Surge Protector, Power Distribution Unit (PDU) or Uninterruptible Power Supply
(UPS). The Power LED will illuminate to indicate the unit is receiving power.
6. Turn on the power to all connected monitors and speakers, then turn on the
power to the DVI and Audio source. The Input Port LED will illuminate to indicate
it is connected to a powered-on source. The Port LEDs will illuminate to indicate
the corresponding port is connected to a monitor and speakers and is receiving
a signal from the source.
Cascade Installation
The number of connected monitors and speakers can be expanded by cascading
up to three levels of splitters together. By cascading a B116-004A from each port in
a three-level installation, you can connect up to 64 sets of monitors and speakers.
The following rules apply to a cascade installation:
• The distance between the source and the splitter must not exceed 16 ft. (5 m).
• For source video resolutions anywhere from 1600 x 1200 @ 60 Hz to
1920 x 1200 @ 60 Hz. The distance between the first-level splitter and any last-
level splitter must not exceed 65 ft. (20 m). The video distance can be extended
by using a B120-000 DVI Extender in between each level of splitters. Each B120-
000 Extender can be located up to 32 ft. (10 m) from a splitter and 16 ft. (5 m)
from the next level splitter or connected monitor.
• For source video resolutions lower than 1600 x 1200 @ 60 Hz. The distance
between the first-level splitter and any last-level splitter must not exceed 98 ft.
(30 m). The video distance can be extended by using a B120-000 DVI Extender
in between each level of splitters. Each B120-000 Extender can be located up to
98 ft. (30 m) from a splitter and 16 ft. (5 m) from the next-level splitter or
connected monitor.
• The B116-002A, B116-002A-INT and B116-004A are designed for monitor
refresh rates of 60 Hz.
5