Edesa EFS-0911 WH/A Manual De Instrucciones página 22

2.2 Temperature Control
( The picture above is only for reference. The actual configuration will depend on the physical
product or statement by the distributor )
● The figures do not mean specific set temperature, but temperature level.
"COLD" means the warmest setting
"COLDER" means the coldest setting
The higher the figure is, the lower the actual temperature inside refrigerator shall be.
"OFF" means stop running.
● Please adjust between "cold" and "colder" gear.
● Recommended gear: "normal"
2.3 Placement
2.4 Installation of door handle
Instruction for handle installation:
1. As shown in the figure, align the two round holes inside the handle base
with the reserved holes on the door
screwdriver to fasten the two hexagon screws
does not shake.
2. Align the handle
base , and push the handle horizontally from left to right as shown in the
figure until it reaches the end.
3. Align the countersunk screw
handle , and secure it tightly.
Note:
To remove the handle, you need to remove the screw
shake the handle to push it out in the opposite direction (from right to left). Be
careful not to push it hard horizontally to avoid hitting your fingers.
●
Before using the refrigerator,
remove all packaging
materials including bottom
cushions and foam pads
and tapes inside the
refrigerator , tear off the
protective film on the door
and the refrigerator body.
●
Keep away from heat and
avoid direct sunlight. Do not
place the refrigerator in
moist or watery places to
prevent rust or reduction of
insulating effect.
(optional)
, and use the self-contained Phillips
with the upper and lower guide slots on the handle
with the reserved hole on the lower side of the
OFF
until the handle base
first, and then slightly
21
●
The refrigerator should be
placed in a well-ventilated indoor
place; the ground shall be flat,
and sturdy.
●
The top space of the refrigerator
shall be greater than 30cm,and
the distances from both sides
and backside shall be more than
10cm to facilitate heat dissipation.
Handle base
Reserved hole on the door
Screwdriver
M5 hexagon screw (two)
Handle
M5 countersunk screw (one)