Edesa EFS-0911 WH/A Manual De Instrucciones página 25

3 Maintenance of refrigerator
3.1 Cleaning
● Dusts behind the refrigerator and on the ground shall be timely
cleaned to improve the cooling effect and energy saving.
● Check the door gasket regularly to make sure there are no debris.
Clean the door gasket with a soft cloth dampened with soapy water or diluted
detergent.
● The interior of the refrigerator should be cleaned regularly to avoid odor.
● Please turn off the power before cleaning interior, remove all foods, drinks
,shelves, drawers, etc.
● Use a soft cloth or sponge to clean the inside of the refrigerator, with two
tablespoons of baking soda and a quart of warm water. Then rinse with water
and wipe clean. After cleaning, open the door and let it dry naturally before
turning on the power.
● For areas that are difficult to clean in the refrigerator (such as narrow sandwiches, gaps or
corners), it is recommended to wipe them regularly with a soft rag, softbrush, etc. and when
necessary, combined with some auxiliary tools (such as thin sticks) to ensure no contaminants or
bacterials accumulation in these areas.
● Do not use soap, detergent, scrub powder, spray cleaner, etc., as these may cause odors in the
interior of the refrigerator or contaminated food.
● Clean the bottle frame, shelves and drawers with a soft cloth dampened with soapy water or
diluted detergent. Dry with a soft cloth or dry naturally.
● Wipe the outer surface of the refrigerator with a soft cloth dampened with soapy water, detergent,
etc., and then wipe dry.
● Do not use hard brushes, clean steel balls, wire brushes, abrasives(such as toothpastes), organic
solvents (such as alcohol, acetone, banana oil, etc.), boiling water, acid or alkaline items, which
may damage the cooler surface and interior. Boiling water and organic solvents such as benzene
may deform or damage plastic parts.
● Do not rinse directly with water or other liquids during cleaning to avoid short circuits or affect
electrical insulation after immersion.
3.2 Defrost
● Refrigerator shall be manually defrosted.
Disconnect the plug from the wall socket, open the door and remove all the food to a cool place.
It is recommended to remove the frost by a plastic scraper, or let the temperature rise naturally until
the frost melts. Then wipe away the remaining ice and water, and plug in socket for switching on
the refrigerator.
It is normal for the evaporator in the refrigerator to frost in use. When you manually defrost,
please use the drain tray to connect the defrosting water.
Other mechanical devices or other means shall not be used to accelerate
except those recommended by the manufacturer. Do not damage the
refrigerant circuit.
3.3 Stop using
Power failure: Foods can be preserved for a couple of hours even in summer in case of power failure;
it is recommended to reduce the frequency of opening door and do not put fresh foods into the refrigerator.
Long-time nonuse:Please unplug the refrigerator left unused for a long time for cleaning.
Keep the door open to avoid the bad odor.
Moving:Do not turn upside or vibrate the refrigerator, the carrying angle can not be greater than 45° .
Do not hold the door and hinge when moving this unit.
Please unplug the refrigerator for defrost and cleaning.
Continuous operation is recommended when the refrigerator
is started. Please do not stop the refrigerator under normal
circumstances so as not to affect the refrigerator's service life.
24