Publicidad
Idiomas disponibles
Idiomas disponibles
2.5 Changing the Light
Any replacement or maintenance of the LED lamps is intended to be made by the manufacturer,
its service agent or similar qualified person.
( Above is only for reference. The actual configuration will depend on the physical
product or statement by the distributor )
2.6 Start to use
2.7 Energy saving tips
● The appliance should be located in the coolest area of the room, away from heat producing
appliances or heating ducts, and out of the direct sunlight.
● Let hot foods cool to room temperature before placing in the appliance. Overloading the
appliance forces the compressor to run longer. Foods that freeze too slowly may lose quality,
or spoil.
● Be sure to wrap foods properly, and wipe containers dry before placing them in the appliance.
This cuts down on frost build-up inside the appliance.
● Appliance storage bin should not be lined with aluminum foil, wax paper, or paper toweling.
Liners interfere with cold air circulation, making the appliance less efficient.
● Organize and label food to reduce door openings and extended searches. Remove as many
items as needed at one time, and close the door as soon as possible.
2.8 Leveling feet
Schematic diagram of the leveling feet
(The picture above is only for reference. The actual configuration will depend on the physical
product or statement by the distributor)
Adjusting procedures:
a. Turn the feet clockwise to raise the refrigerator;
b. Turn the feet counterclockwise to lower the refrigerator;
c. Adjust the right and left feet based on the procedures above to a horizontal level.
(optional)
● The refrigerator shall stay for half an hour before connecting power
when it is firstly started.
● The refrigerator shall run 2 to 3 hours before loading Fresh or refrigerated
foods; the refrigerator shall run for more than 4 hours in summer in
advance considering that the ambient temperature is high.
22
Publicidad
