Foppapedretti Circle i-Size Manual De Instrucciones página 44

Idiomas disponibles

• ENGLISH •

INSTALLATION IN THE VEHICLE

4. BEFORE INSTALLATION

4.1 How to use the buckle

To release the buckle: Press the red button to remove the tabs from the central buckle

(fig. 1).

To attach the buckle: Hold together the central buckle tabs (fig. 2) and insert them

in the special slot inside the harness buckle (fig. 3). A "click" will indicate that it has

attached correctly (fig. 4).

☞ NOTE: to attach the buckle, it is necessary to insert both tabs.

4.2 HOW TO ADJUST THE HARNESS

To tighten the harness: Pull the adjustment strap so that the harness is tight and close

to the child's body (fig. 5).

☞ NOTE: Check that there is a onefinger space (1 cm) between the straps and the

upper part of the shoulders. Make sure that the child is comfortable and protected.

To loosen the harness: Press the adjustment button and at the same time grip the

straps (chest belts) at the bottom, under the pads of the chest protectors, and pull them

forwards to loosen them (fig.6).

IMPORTANT: Do not pull on the shoulder pads.

4.3 HEADREST ADJUSTMENT

IMPORTANT! Correct adjustment of the headrest ensures maximum protection for

your child when they are inside the car seat.

When using the 5-point harness, the headrest must be adjusted so that the straps are

at the same height as the child's shoulders (fig. 7).

WARNING! to a lower height than the child's shoulders, nor to the level of the child's

ears or above. When using the 3-point vehicle seat belt, the headrest must be adjusted

so that there is a two-finger space between the headrest and the child's shoulders.

Make sure that the diagonal belt, when passing through the "diagonal belt guide loop"

on the side of the headrest, is positioned at the shoulders and not at the child's neck

(fig. 8).

To raise the headrest: pull the headrest adjustment strap upwards (fig. 9).

☞ NOTES: Loosen the shoulder straps before adjusting the headrest (for more details

see point 4.2).

To lower the headrest: pull the headrest adjustment strap upwards and press the

headrest downwards (fig. 9).