Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
IMPORTANT: Check motor rotation before operating the compressor.
All lubricated compressor pumps discharge some condensed water and oil with the compressed air. Install
appropriate water/oil removal equipment and controls as necessary for the intended application.
Guarding
All moving parts must be guarded. All electrical covers must be installed before turning on the power.
Recommended Break-In Period
The compressor should be run continuously for 30 minutes at less than 100 PSI to allow proper seating of
the piston rings.
1.
Open tank drain valve completely and run the compressor for 60 minutes.
2.
Turn off the compressor and close tank drain valve. The compressor is now ready for use.
3.
The compressor may emit a high pitch squeaking noise for the first few hours of use. This is normal and
will diminish as the parts break in completely and the bores become smooth from running.
IMPORTANT: Change oil after first 50 hours of operation.
Continuous Run Operation
To convert to continuous run operation a separate unloading device must be installed by the user
between the pump and the tank. The existing check valve must be removed.
Crankcase Breather
During severe operating conditions or initial start-up, some oil may accumulate at the crankcase breather
opening. This is normal and will diminish as the pump accumulates run time and the piston rings become
fully seated.
Moisture in compressed air will form into droplets as it comes from an air compressor pump. When humidity is
high or when a compressor is in continuous use for an extended period of time, this moisture will collect in the
tank. When using a paint spray or sandblast gun, this water will be carried from the tank through the hose, and
out of the gun as droplets mixed with the spray material.
IMPORTANT: This condensation will cause water spots in a paint job, especially when spraying other than water
based paints. If sandblasting, it will cause the sand to cake and clog the gun, rendering it ineffective. A filter in
the air line, located as near to the gun as possible, will help eliminate this moisture.
8 8
Failure to install appropriate water/oil removal equipment may result in damage to machinery
or workpiece.
A belt guard must be installed before operating this unit.
MOISTURE IN COMPRESSED AIR
Publicidad
