Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE AND INSPECTION INSTRUCTIONS
In order to maintain efficient operation of the compressor system, check the air filter and oil level before
each use. The ASME safety valve should also be checked daily. Pull ring on safety valve and allow the ring
to snap back to normal position. This valve automatically releases air if the tank pressure exceeds the
preset maximum. If air leaks after the ring has been released, or the valve is stuck and cannot be actuated
by the ring, the ASME safety valve must be replaced.
Compressor Lubrication
See Installation. Add oil as required. The oil should be changed every three months or after every 500
hours of operation; whichever comes first.
Air Filter
Never run the compressor pump without an intake air filter nor with a clogged intake air filter. Use
compressed air to blow the filter clean. Do not wash or oil the element. If it cannot be blown clean, the
filter must be replaced. Operating compressor with a dirty filter can cause high oil consumption and
increase oil contamination in the discharge air.
Components
Turn off all power and clean the cylinder head, motor, fan blades, air lines, intercooler and tank on a
monthly basis.
Belts
Check belt tension every 3 months. Adjust belt tension to allow 3/8 inch to 1/2 inch deflection with normal
thumb pressure. Also, align belts using a straight edge against the face of the flywheel and touching the
rim on both sides of the face. The belts should be parallel to this straight edge (see Figure 6). Dimension A
should be the same as B and C to ensure proper alignment of the belts.
Slots in the bed-plate allow for sliding the motor back and forth to adjust belt tension.
Air Compressor
Straight Edge
Figure 6 - Top View
12
Disconnect, tag and lock out power source then release all pressure from the system before
attempting to install, service, relocate or perform any maintenance.
Lock out and tag the power then release all pressure from the tank to prevent
unexpected movement of the unit.
Flywheel
Motor
Drive
Pulley
Motor
Setscrew
Publicidad
