Publicidad
Idiomas disponibles
Idiomas disponibles
FITTING THE BATTERIES.-
This
monitor
ALKALINE BATTERIES. To fit the
batteries, remove the rear cover on
the monitor, Fig. 1, and carefully insert
the two "R-6" type batteries into the
battery compartment (A) making sure
that the battery's polarity is correct
(matching the battery's «+» terminal
with the «+» sign inside the battery
compartment, and the «-» terminal
with the «-» sign). Close the cover, as
shown in Fig. 1.
If, after having switched the monitor
on, it displays errors or merely partial
segments then remove the batteries
and wait for about 15 seconds before
reinstalling them.
Weak batteries (run down) produce a
weak digital display (poor contrast)
and erroneous readings. Change them
immediately.
Important. Discarded batteries must
be deposited in special containers,
Fig. 2.
FITTING THE ELECTRONIC
MONITOR.-
Remove the screws (25) from the back
of the monitor Fig 1, then place the
monitor on top of the main post in the
direction of the arrow, Fig. 3, making
sure not to pinch any of the cables.
Refit the screws and tighten, connect
the handgrip terminal (26) to the
conector (32) at the back of the monitor
and the feedback terminal (9) to the
conector (30), as shown in Fig. 3.
uses
two
1.5
English
ELECTRONIC MONITOR.-
volt
To give you greater control over the
exercise, this electronic unit provides
simultaneous
distance, exercise time, calories burnt
and pulse rate.
The screen will switch itself on
automatically as soon as you start
exercising or by pressing any key.
The monitor will switch itself off
automatically if the unit stands idle for
more than 4 minutes and will show
temperature, date and hour.
Pressing the MODE or RESET key for
more than two seconds will reset all of
the values.
delete value set.
A. SCAN FUNCTION.-
In
SCAN
continuously scans and displays all of
the functions during exercise. The
function being displayed will flash on
and off.
To select the SCAN function:
1. The monitor starts in SCAN mode
as soon as exercise begins or if any
key is pressed, the main screen will
display TIME, SPEED, DISTANCE,
CALORIES, PULSE RATE values
every 8
2. Press the MODE key and this will
cancel the SCAN function.
B. TIME FUNCTION.-
This function counts up or down in
steps of one minute, up to a maximum
of 99:00 minutes.
1. Press any key to switch the monitor
on.
2. Press the MODE key to start the
small TIME window flashing.
6
read-outs
Pressing RESET will
mode
the
seconds.
of
speed,
computer
Publicidad
