Publicidad
Idiomas disponibles
Idiomas disponibles
˜ Ironing
m
ATTENTION! Before ironing, check the
ironing instructions on the fabric or article
of clothing . They are usually included on a
sewn-on tag .
m
ATTENTION! Operate the product on an
even and solid surface .
NOTES:
The product can be operated cordless . This
o
makes the product a little lighter . The power
cord
is no longer in the way during
[
8 ]
ironing .
As soon as the product is placed on the
o
stand base
, the soleplate
10 ]
[
up . The temperature control lamp
up until the set temperature is reached .
1 . Turn the temperature control
clockwise all the way to MIN .
2 . Connect the power plug
appropriate power outlet .
3 . Make sure the power cord
safely .
4 . Set the temperature control
temperature .
Temperature control lamp
On
Product has not yet reached
the set temperature and is still
heating up .
Off
The set temperature has been
reached .
5 . Once the set temperature has been reached,
you can begin ironing .
Cordless ironing
NOTE: The arrows on the product
the stand base
10 ]
[
1 . Place the product on the stand base
2 . Wait until the temperature control lamp
goes out .
3 . The arrows
and
product is closed (Fig . C) . Slide the stand
base lock
to
[
9 ]
upwards .
is heating
14 ]
[
lights
[
6 ]
counter-
11 ]
[
with an
8 ]
[
is laid out
8 ]
[
to the desired
[
11 ]
6 ]
[
and on
must be aligned .
.
10 ]
[
6 ]
[
are aligned when the
and lift the product
4 . Start ironing .
5 . To heat up the product again, place it on the
stand base
.
[
10 ]
NOTE: The product is only firmly locked
to the stand base
10 ]
[
the product
and on the stand base
aligned .
Ironing with power cord
1 . Place the product on the stand base
Make sure
and
2 . Wait until the temperature control lamp
goes out .
3 . Once the set temperature has been reached,
you can start ironing .
NOTE: If you want to iron with many steam
bursts in quick succession, ironing with the
power cord
is recommended . Otherwise
[
8 ]
the temperature of the soleplate
below the set temperature faster than normal
as a result of too many steam bursts .
˜ Filling the water tank
m
DANGER! Risk of electric shock!
Always disconnect the power plug
the power outlet before filling the water tank .
m
ATTENTION! Fill the water tank with tap
water or distilled water without any additives .
If your tap water is hard, use distilled water .
Where the water is moderately hard, mix
distilled water and tap water at a ratio of
1:1 .
ATTENTION! Use the measuring cup
m
fill water into the water tank .
NOTE: The water tank has a filling capacity
of approximately 320 ml .
NOTE: The max mark
maximum filling capacity applies when the
product is set up vertically on the stand
base
.
10 ]
[
1 . Tip the product forward at approximately
45° .
2 . Open the lid of the fill opening
3 . Carefully pour water into the water tank . Do
not exceed the max mark
4 . Close the lid of the fill opening
when the arrows on
are
.
[
10 ]
are aligned (Fig . C) .
[
6 ]
may fall
14 ]
[
from
[
8 ]
to
15 ]
[
that marks the
[
13 ]
.
[
2 ]
.
[
13 ]
.
[
2 ]
GB/IE
23
Publicidad
