Toshiba Carrier RBC-AXU31-UL Manual Del Propietário página 9

 High power operation
The Hi POWER (high power operation) mode
automatically controls room temperature, airflow and
operation mode so that the room is quickly cooled in
summer and warmed in winter.
SWING
FIX
Setting Hi POWER mode
1
Hi POWER button
Push the Hi POWER button after starting any
operation. At the same time, the "Hi POWER" mark
on the remote controller is indicated.
Cancelling Hi POWER mode
1
Hi POWER button
Push the Hi POWER button once again.
At the same time, the "Hi POWER" mark on the
remote controller goes out.
CAUTION
• The Hi POWER mode cannot be activated in the
DRY and FAN ONLY operation and when the ON
TIMER operation is reserved.
• When Auto changeover control mode is selected,
the air conditioner does not automatically control the
room temperature.
FAN
QUIET
1
Hi POWER
– 8 –
 Quiet operation
The QUIET mode provides quiet operating status by
automatically setting the fan speed to the lowest speed.
SWING
FIX
Setting QUIET mode
1
QUIET button
Push the QUIET button after starting any operation.
At the same time, the
Cancelling QUIET mode
1
QUIET button
Push the QUIET button once again.
At the same time, the
controller disappears.
• When the QUIET mode is cancelled, the fan
speed changes to AUTO. You can change it to
your preferred speed.
CAUTION
The QUIET mode cannot be activated in the DRY
operation.
NOTE
Under certain conditions, the quiet operation may not
provide adequate cooling or heating due to the feature
of quietness.
FAN
1
QUIET
Hi POWER
mark is indicated.
mark on the remote
8-EN
EN