Midea MDRT489MTE Serie Manual De Usuario página 13

EN
Self-locking
of left door
Self-locking
of right door
6. Install the door of refrigerator chamber on the lower hinge, the middle
hinge on the left side of the refrigerator and tighten the screws, and
place the shaft sleeve well. Install the plug pin in the hole on the
middle beam at the other end.
7. Install the door of freezer on the middle hinge, take out the left upper hinge
and the cover for the left upper hinge from the accessory bag, install the left
hinge and tighten the screws, install the cover for the left upper hinge and
tighten the screw, install the right sensor in the original left hole cover, and then
fix the hole cover on the right box.
8. After completing the installation.
Cover for the
left upper hinge
Left upper hinge
ATTENTION
The picture above is only for reference. The actual configuration will depend on the physical
product or statement by the distributor.
Hole cap
sleeve pipe
Right decorative cover
Support block
Door stop
Sensor
Hole cover
08