Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
DANGER:
DANGER:
Improper connection of the equipment grounding conductor
can result in the risk of electrocution. Check with a qualified
electrician if you are in doubt as to whether the receptacle
is properly grounded. DO NOT modify the plug provided with
this product. If it will not fit the receptacle, have a proper
receptacle installed by a qualified electrician. DO NOT use
any type of adapter with this product.
CAUTION:
CAUTION:
This pressure washer shall only be used with a dedicated
receptacle/plug rated 120vAC, 60 Hz at 15 -or- 20 amperes.
Any other appliances on the circuit should be turned off or
unplugged when using the pressure washer. Never use the
pressure washer with an adapter that may lead to higher
voltage or excessive current. Excessive current may trip circuit
breaker. Consult a qualified electrician if unsure of the desired
power supply receptacle's ability to safely power this pressure
washer.
IT IS NOT RECOMMENDED TO USE AN EXTENSION
CORD. If, however, an extension cord is required, it must be
an OUTDOOR RATED 3-PRONG CORD, that is no longer
than 50 feet (15M) and has a minimum of 14 AWG (2.5mm 2 )
conductors. Always uncoil the extension cord when in use.
DO NOT use an extension cord that has its ground pin
damaged or missing.
• Make sure the "ON/OFF" switch is in the "OFF" position. The
power switch has international symbols for 'on' and 'off': On
(|) Off (O).
• Unwind the power cord completely and plug the GFCI (For US
unit only) into a grounded 120 volt outlet.
• Turn on water supply at the faucet to completely open.
• Release safety push trigger lock up and back into trigger.
While pointing the spray gun in a safe direction, squeeze
the trigger on the spray gun until there is a steady stream of
water, letting the water and air out of the hose. Push trigger
lock back down to lock back into place.
ELECTROCUTION HAZARD
POWER SUPPLY
ON
OFF/0
ON/I
• Turn the power switch to the "ON" (|) position. The unit
will turn on for 1 - 2 seconds and shut off. This is a normal
function of the auto start feature.
• Begin power washing by squeezing the trigger on the spray
gun all the way into the handle.
• Release the spray gun trigger to stop the power washer
• Allow the motor to come to a complete stop before squeezing
the trigger again.
• Squeezing rapidly will cause the auto start feature to miss
an on/off cycle that may prevent it from turning on while
squeezing trigger after rapid squeezing. Use slow deliberate
trigger pulls to avoid such symptoms.
• Always test a small area to avoid chance of damaging the
surface.
OFF/0
ON/I
11
Publicidad
