Publicidad
Idiomas disponibles
Idiomas disponibles
CARE AND MAINTENANCE
Cleaning Nozzles
• A clogged or partially clogged nozzle can cause significant
reduction of water pressure coming out of the nozzle and/or
cause the unit to pulsate while spraying.
• Turn off the unit.
• Turn off the water supply to the unit.
• Relieve any pressure trapped in the hose by squeezing the
trigger 2-3 times, and then lock the spray gun by pushing the
lock button from left to right.
• Remove nozzle from lance.
• Using the nozzle tip cleaner provided (or an unfolded paper
clip), insert the wire into the nozzle hole and move back and
forth until debris is dislodged.
• Tap quick connect end of lance on hard surface several times.
• Back flush water through the nozzles using garden hose and
highest pressure available (either standard water nozzle or
use your thumb over the nozzle to create water pressure for
back flush).
Storage
• When your pressure washer session has been completed,
turn off the power switch located on the front of the power
washer. Unplug the power cord from the outlet. Turn off the
water supply. Pull the trigger on the spray gun 2-3 times to
drain out the excess water and to release any remaining
water pressure. Disconnect the garden hose adapter from
the water inlet. DO NOT allow the power washer to run with
no water flowing through it.
• Remove high pressure hose from spray gun.
• Remove lance from the gun. Place the gun in the holster on
the side. Lances are placed into any of the slots in the back
of the unit.
• Make sure to discard any remaining detergent from the
bottle. Residual chemical will stick to the container which
could become cotaminated, and can cause the detergent
injector to clog and not function properly. Flush the bottle
and nozzle head with fresh water to prevent clogging.
• Hook the power cord around the cord hook on the right side
of the machine when facing it.
• The pressure hose is stored on the hose hook located on the
back of the handle.
•
DO NOT store the power washer where it is exposed
to freezing temperatures unless you use SIMPSON
Pump Guard. Store the power washer indoors to prevent
water in the unit from expanding under freezing conditions.
When the water freezes and expands, your pressure washer
will be damaged and become inoperable. OR, if storing
outdoors, it is recommended you use SIMPSON Pump Guard
(not included) to protect the pump.
13
Publicidad
