GB
MT
- Afteraccidentsoroperatingfaults
- Wheneveryouarenotusingthede-
vice
- Whenyouareleavingthedevice
unattended
- Whencleaningormaintainingthe
device or before inspecting it
- Whentransportingthedevicetoano-
ther location
- Whenremovingorexchangingthe
brush
• Brushesmaynotbemountedtodevices
withrotationalspeedsthatexceedthe
maximumpermissiblebrushspeed.
• Damagedbrushesmaynotbeused.
• Rustdiscolorationorothersignsof
chemical or mechanical changes in the
bristle material can cause premature
failure of the brush.
• Brushesmustbestoredinsuitable
racks,containersorboxesinsucha
way that they are protected against the
followinginfluences:
- Highhumidity,heat,waterorother
liquids that could lead to damage of
the brush
- Acidsoracidvaporsthatcouldresult
in damage
- Temperaturessolowthattheycould
lead to condensation on the brushes
if these are relocated to an area with
higher temperatures
- Deformationofanybrushcomponent
• Do not use accessories that were not
recommended by PARKSIDE. They can
causeelectricshockorfire.
Residual risks
Evenifproperlyoperatingandhandling
this electric tool, some residual risks will
remain. Due to its construction and build,
this electric tool may present the following
hazards:
22
a) Eyedamageifworkingwithouteye
protection.
b) Eardamageifworkingwithoutearpro-
tection.
c) Damagetoyourhealthcausedby
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.
Warning! During operation, this
electric tool generates an electro-
magneticfieldwhich,undercertain
circumstances, may impair the func-
tionality of active or passive medical
implants. To reduce the risk of seri-
ous or lethal injuries, we recommend
that persons with medical implants
consult their doctor and the manu-
facturer of their medical implant
before operating the machine.
Assembly instructions
Assembling the device
1.Pushthecenterpiece(7)ontothecenter
piece(10).
2.Pushthegrippiece(5)ontothecenter
piece(7).
3.Securethecenterpiece(7)withfourPhil-
lipsscrews(6).
Assembling the splash
guard and guide roller
1.Pushthesplashguard(8)ontotherail
ofthecenterpiece(10)untilitclicks
into place.
2.Pushtheguideroller(11)intotherecei-
veronthecenterpiece(10).