Safety And Installation Instructions - Waeco PerfectView M59L Instrucciones De Montaje

_M59L_EB_10s.book Seite 37 Dienstag, 22. Januar 2008 4:59 16
PerfectView
2

Safety and installation instructions

Please observe the prescribed safety instructions and stipulations
from the vehicle manufacturer and service workshops.
a
Caution!
The manufacturer will not be held liable for claims for damage re-
sulting from the following:
– Installation errors
– Damage to the device resulting from mechanical influences and
overvoltage
– Alterations to the device without express permission from the
manufacturer
– Use for purposes other than those described in the operating
manual
e
Warning!
To prevent the risk of short circuits, always disconnect the negative
terminal of the vehicle's electrical system before working on it.
If the vehicle has an additional battery, its negative terminal should
also be disconnected.
e
Warning!
Inadequate supply cable connections could result in short circuits,
which could have as a consequence that:
– Cable fires occur
– The airbag is triggered
– Electronic control devices are damaged
– Electric functions fail (indicators, brake light, horn, ignition,
lights)
Please observe the following instructions:
When working on the following cables, only use insulated cable lugs,
plugs and flat push-on receptacles:
– 30 (direct supply from positive battery terminal)
– 15 (connected positive terminal, behind the battery)
– 31 (return cable from the battery, earth)
– 58 (reversing light)
Do not use terminal strips.
Use a crimping tool (fig. 1 10, page 3) to connect the cables.
Safety and installation instructions
37