Installing The Monitor - Waeco PerfectView M59L Instrucciones De Montaje

_M59L_EB_10s.book Seite 47 Dienstag, 22. Januar 2008 4:59 16
PerfectView
8.2

Installing the monitor

d
Warning
Select the location of the monitor so that it cannot injure the pas-
sengers in the vehicle under any circumstances (e. g. sudden brak-
ing, road traffic accidents).
Observe the following installation instructions:
Select an installation location that provides an unobstructed view of the
monitor (fig. e, page 8 and fig. f, page 8).
Never install the monitor in an area where your head could knock against
it or in the air bag deployment path. This could cause injury if the airbag
opens.
The monitor must not impair your vision when driving (fig. g, page 8).
The installation location should be flat.
Ensure that the contact area between the monitor base and the installa-
tion surface is as large as possible.
Check that there is sufficient space underneath the installation location to
attach the washers and nuts.
Check beforehand that there is sufficient space on the other side for the
drill head to come out (fig. 2, page 4).
Bear in mind the weight of the monitor. Provide reinforcement if necessary
(larger washers or plates).
Ensure that you can lay the connection cable to the monitor.
To perform the installation, proceed as follows:
Fasten the monitor to the monitor base (fig. h, page 9)
➤ Fasten the monitor (fig. h 1, page 9) to the monitor base (fig. h 2,
page 9) by leading the top of the base through the opening on the rear of
the monitor fig. h 3, page 9).
➤ Fasten the monitor and the monitor base with the aid of knurled screws
(fig. h 4 und 5, page 9).
Installing the LCD monitor
47