Waeco PerfectView M59L Instrucciones De Montaje página 48

_M59L_EB_10s.book Seite 48 Dienstag, 22. Januar 2008 4:59 16
Installing the LCD monitor
I
Note
If the monitor angle has to be readjusted, unscrew the knurled
screws (fig. h 4 und 5, page 9).
After the adjustment of the monitor angle, screw the knurled screws
back in.
➤ Position the monitor and the attached monitor base for testing.
➤ Mark the outlines of the corners of the monitor base on the dashboard.
➤ Unscrew the monitor from the monitor base.
➤ Clean the chosen installation location before definitively mounting the
monitor base.
➤ Pull the red protective film off the monitor base.
➤ Press the monitor base firmly against the top of the dashboard.
I
Note
If necessary, use 4 x 12 mm self-tapping screws to securely fasten
the monitor base to the dashboard.
If you want to secure the monitor base with self-tapping screws
(fig. i, page 9):
a
Caution!
Self-tapping screws may only be fastened to steel metal with a
minimum thickness of 1.5 mm.
➤ Hold the monitor base within the outlines marked beforehand and mark
three different drilling points (fig. i, page 9).
➤ Using a hammer and centre punch, gently pre-punch the previously
marked points to prevent the drill head from slipping off.
➤ Drill Ø 3.5 mm holes at the points you have just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Screw on the monitor base with the 4 x 12 mm self-tapping screws.
➤ Mount the monitor on the monitor base as described in section „Fasten
the monitor to the monitor base (fig. h, page 9)" auf Seite 47.
48
PerfectView