Starmix AV P-615 Manual De Instrucciones página 19

4.6 REMOVING AND CLEANING FILTER
Take off the head and put it upside down (Fig. 10)
If the vacuum cleaner is equipped with a pre-filter, carefully pull it off (A), clean it (B), let it dry (C) and
put everything back together when it is dry (D). Check that the filter is properly seated.
To change or clean the main filter, loosen the 4 screws and remove the parts (A). If the filter is damaged,
replace it with a new one and assemble it in the same way. Be careful not to overtighten the screws.
If the filter is dirty, wash it under cold water (B) and let it dry (C). Replace the filter after it has dried.
Fig.10
This vacuum cleaner can be equipped with a built-in thermal overload protector to protect the motor from
high temperatures. This can occur under heavy use. If the motor temperature shuts off during
operation, turn the switch off and allow the motor to cool for 15-30 minutes. Turn switch on and resume
operation.
5. TROUBLE SHOOTING
Repair or service of electrical components such as cord or motor, must only be carried out by an
authorized service center.
Vacuum does not start:
Motor stops:
S u c t i o n p o w e r is
reduced:
Static shocks:
- Check to see that the plug is correctly inserted in the electrical outlet and that
there is power at receptacle.
- A circuit breaker may have tripped. Check the circuit breaker box.
- The cord or plug may be damaged. Call the Customer Service Department to
get the nearest authorized service center.
- A thermal overload protector will shut off the motor if the motor temperature
is too high. If this occurs, turn the switch off. Wait 15-30 minutes for the motor
to cool. Turn switch on and resume operation.
- The tank may be full and needs to be emptied. See Fig. 8
- The hose and nozzle may be clogged and need to be cleaned.
- Any of the above may be damaged and need to be replaced.
- The filter may be clogged. Use the Filter Cleaning System (see Fig 9), to
clean the filter.
- Replace the filter or make sure the filter is installed properly.
- The hose connection is loose and need to be tightened.
- If the environment is too dry, add moisture to air. If possible, use a humidifier.
- In case the relative humidity of air is low, please note that this situation will
not have any effect on use of the vacuum cleaner.
- 19 -