Phonocar VM168 Manual De Instrucciones página 35

4
GENERAL CONNECTION DIAGRAM
WARNING! Disconnect the negative terminal of the vehicle battery when making connections.
For additional cameras, proceed with the installation one camera at a time, keeping in mind that the pairing procedure
with the monitor should be carried out at a distance of no more than 15 m.
Once the pairing is done, the cameras can also be installed at a distance of more than 15 meters.
1
5
MONITOR (1)
Disconnect the negative terminal of the vehicle battery.
Connect the power wiring (7a) to the monitor (1).
Connect the black wire to ground and the red wire to an ignition
key (+15).
Use the provided t-type connectors should it be necessary.
CAMERA (5)
Connect the power wiring (7b) to the camera (5).
Connect the black wire to ground and the red wire to ignition key
positive (+15) or vehicle position/marker light.
Use the provided t-type connectors should it be necessary.
Reconnect the negative terminal of the vehicle battery and turn on
the ignition.
Check that the monitor and camera have been installed correctly-
the monitor will automatically turn on and full-screen camera
images will be displayed.
If the monitor does not turn on automatically, press the POWER
button (A) and see if you can see the camera images.
N.B. The supplied monitor and camera are already matched.
If camera images are not automatically displayed when the monitor
is turned on, proceed to manual pairing (see Chapter 7.1 "Camera
and Monitor Pairing").
7a
7a 7b
7b
ADDITIONAL CAMERAS
(up to a maximum of 4 cameras total) code Phonocar VM486
N.B. PROCEED TO INSTALL THE ADDITIONAL CAMERAS
ONE AT A TIME.
Disconnect the negative terminal of the vehicle battery.
- Make the connections before fixing the camera at a distance of no
more than 15 m to allow the pairing enable procedure to be carried
out with the monitor.
- Connect the additional camera (VM486) to the power harness
provided in the package equal to harness 7b.
- Connect the black wire to ground and the red wire to ignition key
positive (+15) or vehicle position/marker light.
- Reconnect the negative terminal of the vehicle battery.
- Turn on the panel and proceed to enable the new camera via the
monitor, see Chapter 7.5 "Manual Camera Enable/Disable.".
- After enabling it, pair the camera with the monitor, see Chapter
7.1 "Pairing Cameras and Monitors.".
- Verify successful pairing by clicking on the "CHANNEL" button (D)
to display the paired cameras and the type of display.
Repeat the operation for all additional cameras.
35
VM168
EN
POWER SUPPLY WIRING
mass
positive ignition key