Charging Indications; Battery Charging Procedure; Work Area Temperature; Initial Assembly - CAMPAGNOLA EASY S Manual De Uso Y Mantenimiento

4.2

Charging indications

Led lights
3 green led lights
2 green led lights
1 green led lights
1 red led light
Battery charger
Indication
Red
Green
4.3

Battery charging procedure

•
Charge the battery indoor.
•
Make sure the battery switch is in OFF position before charging.
•
Properly connect the charger to the battery.
•
Make sure the specifications of the battery and the charger are the right ones before charging.
•
The red led light on the charger indicates it is charging the battery, the green led light indicates that the battery is
fully charged. The average charging time is 4-5 hours.
•
Disconnect the charger when the battery is fully charged.
•
During periods of tool inactivity, store the battery fully charged and be sure to recharge it at least every 6 months.
4.4

Work area temperature

•
Recharging can be carried out only at a temperature between 0°C and + 45°C. The tool can be used only at a
temperature between -10°C and +60°C.
•
Keep the tool at a temperature between -5°C and +30°C when working
4.5

Initial assembly

Before starting assembly, please check that tool, cable and battery are clean and dry, then carry it out according to
the following steps:
•
Take the backpack out of the plastic box
•
Put the battery into the backpack.
•
Connect the battery cable on the right. By reversing the position of the battery in the backpack, it is possible to
choose the cable output direction as well as the hand holding the tool.
•
Double check nobody is around you
•
Connect the cable to the pruning shear:
•
Wear the backpack and fasten its belt
•
Check if the blades are closed
•
Hold the shear handlegrip tightly
Page 30
Lithium ions battery
Battery charge
80%-100%
50%-80%
30%-50%
< 30%
State
Charging
Full charge
Voltage
34 V <Vcc ≤ 42 V
Vcc ≤ 34 V
Use and Maintenance Manual – Original
Instructions Rev.: 02, Date 19/07/2019