Silk’n Motion Premium H3220 Instrucciones De Uso página 19

5. Decide if you wish to treat the area by Gliding or Pulsing
(refer to section 6.3 Pulsing and gliding).
6. Apply the treatment surface (#6) to the skin. Make sure
that the skin is spread evenly and smoothly. When the
treatment surface (#6) is in full contact with the skin, the
ready light (#3) will start blinking slowly.
7. The device will first determine the color of your skin
automatically, and it will flash a pulse of light onto your
skin. You will feel a mild sensation of warmth and tingling,
and you may hear a popping sound.
8. If you are pulsing, remove the device from your skin. The
device will immediately recharge for the next pulse. After
a few seconds (depending on the energy level) the ready
light (#3) will turn on again, and start blinking slowly when
pressed against the skin.
9. If you are pulsing, repeat the process. If you are gliding,
simply continue. Continue to pulse or glide until you have
treated the area fully.
C
Stop use immediately, if your skin blisters or burns.
8. After treatment
When you have finished your treatment session:
1. Turn the device off by giving the control button (#4) an
extended press. Remember the last energy level setting
you used, because it will not be restored when you turn
the device on again.
2. Remove the adapter from the electrical outlet.
17
EN