Connecting The Power Cable; Turning On And Off The Power; Turning On This Unit - Yamaha RX-V363 Manual De Instrucciones

Connecting the wire of the AM loop antenna
Open the Insert
lever
y
The wire of the AM loop antenna does not have any polarity
and you can connect either end of the wire to AM or GND
terminal.
Assembling the supplied AM loop antenna
Note
The types of the supplied AM loop antenna is different
depending on the models.

Connecting the power cable

Close the
lever Once all connections are complete, plug the power cable
into the AC wall outlet.

Turning on and off the power

■ Turning on this unit

Press A STANDBY/ON (or A POWER) to turn
on this unit.
y
When you turn on this unit, there will be a 4 to 5-second delay
before this unit can reproduce sound.
■ Set this unit to the standby mode
Press A STANDBY/ON (or 2 STANDBY) to set
this unit to the standby mode.
Note
In the standby mode, this unit consumes a small amount of power
in order to receive infrared signals from the remote control.
Connections
Power cable
To the AC wall outlet
19
En