DeWalt DCN21PL Manual De Instrucciones página 12

English
Proper Hand Position (Fig. E)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the handle
Fig. E
14
Mode Selection (Fig. F, G)

WARNING: Always wear proper eye [ANSI Z87.1
(CAN/CSA Z94.3)] and ANSI S12.6 (S3.19) hearing
protection when operating tool.
The D WALT cordless nailers are assembled in accordance
e
with the ANSI Standard SNT-101-2002.
The framing nailer is capable of firing nails using bump
actuation or sequential actuation. If you would like to
have the bump actuation mode disabled, have the tool
serviced by an authorized D
e
operating this tool, look at the selector switch to determine
the actuation mode. Read all instructions before selecting
actuation mode.

WARNING: Keep fingers AWAY from trigger when
not driving nails to avoid accidental firing. NEVER
carry tool with finger on trigger. In bump mode tool
will fire a nail if contact trip is bumped while trigger
is depressed.
Sequential Action
Use sequential action for intermittent nailing where
very careful and accurate placement and depth control
is desired. The sequential actuation mode provides the
maximum delivery of power for driving the longest nails.
To Operate the nailer in sequential Action Mode
1. Slide the selector switch
Figure F.
2. Fully depress nosepiece against the work surface (motor
will start).
3. Pull trigger (nail will drive into work surface).
4. Release trigger.
5. Lift nosepiece off work surface.
6. Repeat steps 2 through 4 for next application.
10
14
WALT service center. Before
9 to the left, as shown in
NOTICE: The contact trip needs to be depressed
followed by a trigger pull for each nail followed by
a release of both the contact trip and trigger after
each nail.
Fig. F
.
Bump Action
Bump action is intended for rapid nailing on flat, stationary
surfaces and typically most effective for applications that
require driving shorter nails.
When using bump action, two methods are available: place
actuation and bump actuation.
Slide the selector switch
Figure G.
Fig. G
To Operate the Tool Using the Place Actuation Method

WARNING: A nail will fire each time the
trigger is depressed as long as the contact trip
remains depressed.
1. Depress the contact trip against the work surface.
2. Depress the trigger.
To Operate the Tool Using the Bump Actuation Method
1. Depress the trigger.
2. Push the contact trip against the work surface. As long
as the trigger is depressed, the tool will fire a nail every
time the contact trip is depressed. This allows the user
to drive multiple nails in sequence.

WARNING: Do not keep trigger depressed when tool
is not in use. Keep the trigger lock-off in the locked
position when the tool is not in use.

WARNING: When the tool's motor is running, the
next actuation, pulling the trigger or depressing the
contact trip, will cause a nail to fire.
9
9 to the right, as shown in
9