Publicidad
Idiomas disponibles
Idiomas disponibles
EN
5. PROGRAMMING OF OPERATIONS
Follow the programming steps in this section carefully. Take your time to get the programming right the first
time. It is helpful to have a second person read the programming steps in the manual while you enter values
using the control buttons.
Operating modes :
These pumps have two operating modes: Manual and Automatic. You can switch back and forth to your
preferred operating mode. To switch from one mode to the other, press the "UP" and "DOWN" buttons at the
same time.
1.0 - OPERATING MODE MANUAL MODE
1.1 - The manual mode has four default speeds: "LOW", "MEDIUM", "HIGH", "FULL".
Speed table
Lowest speed
Maximum speed
Default speed
1.2 - The default speeds cannot be changed. However, you can set a pump speed temporarily to a default
setting using the "UP" or "DOWN" buttons.
1.3 - Once the temporary speed has been set, press the "SET" button to move to the next default speed.
1.4 - In manual mode, if you switch off the pump, the current speed can be saved automatically the next time
the pump is used.
2.0 - AUTOMATIC OPERATING MODE
To start programming the automatic mode, press
"SET" once.
The automatic mode will not work until the
current time and the time and speed settings are
programmed. Follow the instructions below to
program the current time and the time and seed
settings for each segment.
*In manual mode, the pump operates at the constant
speed set by the user.
LOW
MEDIUM
1150
1150
3450
3450
1150
1700
HIGH
FULL
1150
1150
3450
3450
2800
3450
Publicidad
