Publicidad
Idiomas disponibles
Idiomas disponibles
2.1 – PROGRAMMING
To set the current time, press and hold the "RUN/
STOP" and SET" buttons simultaneously for 3
seconds. The time setting will flash. Use the «UP» or
"DOWN" button to adjust the current time. When the
time is correct, press the SET button once to move
to the minute setting. The minute setting will flash.
Press the UP or DOWN button to set the current
minute (see picture 3).
2.2 - THE SEGMENTATION TIMES AND RUNNING
SPEEDS OF THE PROGRAM «T» :
• A maximum of 4 time segments can be
programmed. Each timing segment consists of
three parameters: «Start time», «End time» and
«Running speed». The segments are indicated on
the display by «T1», «T2», «T3» and «T4». After
setting, the pump runs at the programmed speed
within the defined times. The times and speeds are
saved when the power is switched off.
• When you program the time and speed parameters
for the first time, the programming automatically
starts with the first time and speed segment, «T1».
• When programming a time and speed segment, all
parameters (start time, end time and stroke speed)
must be changed. The currently programmed
parameter flashes.
• Press the SET button to begin programming your
«T1» time and speed segment. Use the «UP» or
«DOWN» buttons to program the start time, end
time and operating speed.
The current setting will flash. When the time or speed
is set as desired, press «SET» to save it. The next
setting will flash. Continue to set the start time, end
time and speed until you have finished. Once you
have programmed the first segment, press and hold
the SET button for 3 seconds to save and exit this
segment.
Press the "DOWN" button to move to the "T2"
segment you wish to program. Repeat the process
used to program the first time and speed segment.
• Continue the process through "T3" and "T4"
until you have programmed as many of the four
available time and speed segments as you wish.
It is not necessary to program all four time and
speed segments.
• If you make a mistake while programming the
time and speed in a segment, you can go back
by pressing "SET" once. Then move to the time or
speed setting you wish to change by pressing the
SET button until that setting flashes. Use the UP or
DOWN button to change the setting.
• If, during the process of programming a "T"
segment, you do not press a button and more
than 8 seconds elapse, the programming of that
"T" segment will be automatically saved and
abandoned. You can return to this segment by
pressing the DOWN button once and then the SET
button until you return to the segment you were
programming. Proceed with the normal segment
programming steps.
• When programming a "T2", "T3" or "T4" segment,
the programmed times may not overlap with the
times of other segments. If this happens, the
programming of this segment cannot be saved.
Go back and start programming this segment
again as explained above.
• To quickly delete the current settings of the "T"
segment, set the start time to "23" and press the
"UP" button once, the setting for this segment
will be deleted. Or, set the start time to "00" and
press the "DOWN" button once, the setting for this
segment will be deleted.
• See the button functions below for additional
programming information.
EN
Publicidad
