Parkside PRM 1800 C3 Instrucciones De Utilización Y De Seguridad página 39

Rules of operation
The following rules must be observed at all
times when working on and with the lawn
mower.
- Do not adjust the device or rectify
faults when it stands still. Make sure
that the device cannot start up.
- Only lift the device on the grip and
handle. Never reach underneath the
device to lift it.
- Let the blade run to a stop before
touching the device or the collecting
bag again.
- Never reach beneath the discharge
flap or into the discharge chute.
- Stop the motor immediately if you
notice unusual mowing sounds or
vibrations. Check and rectify cause of
the fault before resuming mowing.
- Never put a damaged device into
operation. Any damage to the blade
and the device must be repaired by
the manufacturer's customer service or
qualified personnel.
- Mow diagonally to inclinations.
- Use a circuit breaker with a tripping
current of 30 mA or less.
- The device is intended for use in
spaces with a current carrying
capacity ≥100 A per phase supplied
by a distribution grid with a mains
voltage of 400/230 V. Please contact
your local supplier to establish
whether the current carrying capacity
Safety / Preparation / Mounting
on the interface to the device is
adequate.
● Preparation
Note: Remove all packaging material from the product.
Remove all protective films before first use.
● Mounting
Installing the handlebars
□ Unfold the bottom handlebars 6 and secure them
in the desired position using the previously installed
screws.
□ Position the handlebars 2 onto the bottom handle­
bars 6 .
The connection cable 16 must not be trapped
between the handlebars 2 and the bottom handle­
bars 6 .
□ Turn the wing nuts counter-clockwise to unscrew them
from the screws with wing nuts 5 .
□ Align the holes of the handlebars 2 and the bottom
handlebars 6 with each other and insert the screws
into the handlebars from the inside towards the
outside.
□ Tighten the associated wing nuts clockwise and
handtight onto the screw threads.
□ Secure the connection cable 16 on the handlebars
with cable clamps 17 .
The connection cable 16 must be routed below the
strut of the bottom handlebars 6 .
Attaching the cuttings collec­
tion bag
□ Clip in the cuttings collection bag handle 18 on the
top of the cuttings collection bag 7 .
□ Pull the plastic lips of the cutting collection bag 7
over the steel frame from the inside.
□ Check whether the plastic lips have engaged on all
sides.
□ Completely lift the discharge flap 8 .
□ Attach the cuttings collection bag 7 on the hooks
above the discharge chute.
GB/IE/NI/CY/MT 39