Electrolux ENG7TE18SX Manual De Instrucciones página 24

24 www.electrolux.com
Problem
appears on the
display.
The
pears and the alarm indi‐
cator is on.
The
or
the current setting appear
alternately every 5 sec‐
onds and the alarm indica‐
tor is on.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
8.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
Possible cause
The door has been opened
often.
The Extra Freeze function
is switched on.
The Extra Cool function is
switched on.
There is no cold air circula‐
tion in the appliance.
The appliance is in the
demonstration mode.
Communication problem.
symbol ap‐
Temperature sensor prob‐
or
lem.
symbol and
Solution
Open the door only if nec‐
essary.
Refer to "Extra Freeze
function" section.
Refer to "Extra Cool func‐
tion" section.
Make sure that there is
cold air circulation in the
appliance. Refer to "Hints
and tips" chapter.
To exit the demonstration
mode, press and hold the
Extra Cool and ECO but‐
tons for approximately 10
seconds until you hear 3
short beeps.
Contact the nearest Au‐
thorised Service Centre.
The cooling system will
continue to keep food
products cold, but temper‐
ature adjustment will not
be possible.
Contact the nearest Au‐
thorised Service Centre.
The cooling system will
continue to keep food
products cold, but temper‐
ature adjustment will not
be possible.
8.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to installation instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.