Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Requirements
Electrical Requirements
WARNING
•
The owner shall verify that the electrical service meets electrical requirements and that the outlet is properly
installed by a licensed electrician.
•
To reduce risk of fire, electric shock, or personal injury:
-
Do not use an extension cord or adapter plug with the rangetop.
-
The rangetop must be properly grounded.
-
Do not use a damaged power plug or loose wall outlet.
-
Do not modify, remove, or otherwise defeat the plug's grounding (3 rd) prong. If you have a 2-
prong outlet, or you suspect the outlet is not properly grounded, have a qualified electrician
check the circuit and outlet; install the proper outlet if needed.
-
All wiring and grounding must comply with local codes or, in their absence, the National
Electrical Code, ANSI/NFPA No. 70 - Latest Revision (US), or the Canadian Electrical Code
CSA C22.1 - Latest Revisions and local codes.
-
The wiring diagram is inside the burner box.
-
All gas models are equipped with a power cord with an equipment-grounding conductor and
a grounding plug.
-
All gas models in the US and Canada require a 120 V, 60-Hz, AC, approved electrical service
with 20-amp circuit breaker or time-delay fuse.
-
NEVER connect ground wire to plastic plumbing lines, gas lines, or water pipes.
NOTE
Re-ignition may malfunction if the voltage between Neutral and Ground is over 20 VAC.
Make sure the voltage is under 20 VAC.
CAUTION
Failure to follow these instructions can cause fire, electrical shock, death.
Additional installation requirements for mobile homes:
Installation of appliances designed for mobile-home use must comply with the Manufactured Home Construction
and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile-Home Construction and
Safety, Title 24, HUD, Part 280) or, when the standard does not apply, the Standard for Manufactured-Home
Installations, latest edition (Manufactured-Home Sites, Communities and Setups), ANSI A225.1, latest edition, or
with local codes. In Canada, mobile-home installation must comply with the current CAN/CSA Z240/MH Mobile-
Home Installation Code.
18
English
DTT48T963_DG68-01475A-00_EN+MES+CFR.indb 18
DTT48T963_DG68-01475A-00_EN+MES+CFR.indb 18
2022-11-24 오후 12:55:21
2022-11-24 오후 12:55:21
Publicidad
