Publicidad
ASSEMBLY
Squeegee Assembly
1. Maintain the squeegee support (1) slightly lifted from the floor.
2. Insert the threaded parts of the two knobs (2) making them slide inside the
two slots present on the support. Pay attention to put the washers (3) into
position, there are two for each knob, so that they are assembled one under
and the other on top of the two slots present on the support.
3. Block the squeegee by rotating the two knobs (2) clockwise.
4. Insert the squeegee hose (4) into its coupling, respecting its position as
indicated in the figure.
Adjustment Of The Squeegee
In order to have a perfect drying result of the squeegee, the rear rubber must
have the lower bending uniformly adjusted in its length. For the adjustment, it is
necessary to put oneself in working condition and therefore the suction motor has
to be switched on and the base has to function together with the detergent solution.
14
Publicidad
