Publicidad
ASSEMBLY
The bending is not uniform
Adjust the squeegee inclination rotating counterclockwise the wing nut (1) to
increase the bending in the central part, or clockwise to increase the bending on the
extremities.
Height adjustment
Once the squeegee inclination has been adjusted, it is necessary to fix this optimum
condition making the wheels slightly touch the floor. Release the wheels rotating
counterclockwise the register (2), rotate the register (3) to raise or to lower the
wheels until the desired bending is reached.
At the end block again the wheels through the register (2).
Pad Assembly
To secure the pad proceed as follows:
Use switch (1) to lift the base.
Place the pad under the base, then lower it using switch (1).
15
Publicidad
