Publicidad
FAULT DIAGNOSIS
Excessive Foam Production
Check that low foam detergent has been used. Eventually add small quantities of
anti foam liquid into the recovery tank.
Please be aware that a bigger quantity of foam is produced when the floor is not
very dirty. In this case please dilute detergent solution.
Notice
TS350-W20-UE
Your machine is equipped with the NexSys battery system. This system has a POD
(Protection from Over Discharge) device attached that analyzes battery voltage and
the State Of Charge (SOC) during operation and storage. When the unit reaches the
level where the batteries need to be charged, the device issues a audible (beep)
and visual (blink) reminder. A light will blink on the control panel (1) and the POD
will beep. It is important that the batteries be charged at this point.
1
Failure to follow the above procedure will void the battery
warranty!
34
Publicidad
