Publicidad
Idiomas disponibles
Idiomas disponibles
equipment into the unit and operate normally. Ensure that the wattage
of all equipment simultaneously plugged into the unit does not exceed
140 watts continuous through the supplied 12VDC adapter plug (up to
115W for the AC outlets and up to PD 25W for the USB ports), 1000
watts continuous via the supplied Battery clamps (up to 1000W for
the AC outlets and up to PD 25W for the USB ports), and 300 watts
through a DeWALT® 20V Battery Pack (not included) (up to 275W for
the AC outlets and up to PD 25W for the USB ports).
CAUTION – To avoid the risk of property damage: Always connect
the unit to the power source before plugging any devices into the unit.
Connection to Power Source
The Power Inverter comes equipped 12VDC Adapter Pug and Battery
Clamps for connection to a power source.
The unit also has battery pack terminal connector for DeWALT® 20V
Battery Pack.
CONNECTING TO A POWER SOURCE USING THE PROVIDED
BATTERY CLAMPS
Use the provided Battery Clamps to connect the Power Inverter directly
to the 12 volt power source as follows:
1. Check to make sure that the inverter is turned off and no flammable
fumes are present in the installation area.
2. Open the red (positive) plastic protective cap (downward). Using
a Phillips head screwdriver, unscrew the connection screw
(counterclockwise) and remove it. Attach the positive O-ring
connector at the end of the red battery clamp cable to the positive
connection post. Replace the connection screw and screw it
clockwise to secure. Do not over-tighten.
3. Connect the red battery clamp to the POSITIVE terminal of the
battery.
4. Open the black (negative) plastic protective cap (downward).
Using a Phillips head screwdriver, unscrew the connection screw
(counterclockwise) and remove it. Attach the negative O-ring
connector at the end of the black battery clamp cable to the
negative connection post. Replace the connection screw and
screw it clockwise to secure. Do not over-tighten.
5. Connect the black battery clamp to the NEGATIVE terminal of
the battery.
6. Make sure that all connections between cables and terminals are
secure.
7. Press and hold the power button for one second to turn the inverter
on. A beep will sound, the backlit LCD and the Battery Clamps
Input LED Indicator will activate to indicate the inverter is operating
properly and the 120 volt AC Outlets are ready to power appliances
that draw up to 1000W continuous. The USB outlets are turned
on as well.
Note: Refer to "Power and Fault Indicators on the LCD Display" for
an explanation of the operating and fault icons. If a fault icon appears,
refer to the "Protective Features" section and the "Troubleshooting"
section of this manual.
DIRECT HARDWIRING TO POWER SOURCE (OPTIONAL
CONNECTION METHOD; HARDWARE NOT INCLUDED)
Use #8 AWG wire if the inverter to power source connection is 4 feet
or less. For cable lengths up to 10ft use #6 AWG wire.* In either case,
protect the positive (+) wire from shorts by installing a 150 amp fuse
or circuit breaker close to the DC power source (battery) terminal.
The cable, fuse holder and fuse (not supplied) can be purchased at
an electrical supply company. Manufacturer provides the installation
cable set (refer to the "Installation" section of this manual).
*For cable lengths exceeding 10 feet from inverter to battery, contact
manufacturer for additional information.
1. Check to make sure that the inverter is turned off and no flammable
fumes are present in the installation area.
15
Publicidad
