Descargar Imprimir esta página

DeWalt DXAEPIP3W Manual De Instrucciones página 7

Inversor de la energía de 1000 vatios y 3 vías

Publicidad

Idiomas disponibles

Idiomas disponibles

• Always connect the inverter to the 12 volt DC power source or
DeWALT® 20V Lithium-Ion Battery Pack before plugging any devices
into the unit.
• The standard North American 120 volt AC and USB outlets
allow simultaneous operation of multiple devices. Simply plug the
equipment into the unit and operate normally.
• Ensure that the wattage of all equipment simultaneously plugged
into the inverter does not exceed 115 watts continuous through the
supplied 12VDC adapter plug, 1000 watts continuous via the supplied
Battery clamps, and 275 watts continuous through a DeWALT® 20V
Battery Pack (not included) or the unit may overload and shut down.
CAUTION – Rechargeable devices
• Certain rechargeable devices are designed to be charged by plugging
them directly into an AC receptacle. These devices may damage the
inverter or the charging circuit.
• When using a rechargeable device, monitor its temperature for the
initial ten minutes of use to determine if it produces excessive heat.
• If excessive heat is produced, this indicates the device should not
be used with this inverter.
• This problem does not occur with most of the battery-operated
equipment. Most of these devices use a separate charger or
transformer that is plugged into an AC receptacle.
• The inverter is capable of running most chargers and transformers.
CAUTION – Incompatible products: Certain products contain power
supplies or circuits that are not compatible with an inverter using a
modified sine wave output (such as this inverter) and may be damaged
by using this inverter.
If your product requires pure sine wave AC input power to function
properly, the instruction manual for your product could state this. If in
doubt, you should contact your product manufacturer PRIOR TO USE.
Some products must be powered from a pure sine wave power source,
such as standard household power, or a "pure sine wave" inverter in
order to function properly.
Your product could be damaged by this inverter if it contains:
• Microwave ovens;
• Transformerless battery chargers
• Capacitive coupled power supplies
If an incompatible product is used with this inverter:
• The product might not operate at all, with no indication of failure. The
product fuse might open as a result of trying to use it with the inverter.
• The product might exhibit unusual operation (such as, intermittent
operation, buzzing, and the like.)
NOTES:
A. Some laptop computers may not operate with this inverter.
B. Some USB-powered household electronics will not operate
with these USB Ports. Check the manual of the corresponding
electronic device to confirm that it can be used with this type of
USB Port.
WARNING: If the product does not operate normally, to
reduce the risk of injury or property damage, turn the product
off immediately and unplug it from the inverter.
NOTICE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to ratio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
6

Publicidad

loading