Publicidad
Idiomas disponibles
Idiomas disponibles
Fuse Replacement (in the 12VDC
Adapter Plug)
1. Unscrew the flange of the plug (counterclockwise).
2. Remove the end contact, flange and fuse.
3. Inspect the fuse to see if it is good or blown.
4. Replace with a new 15 amp fuse, if needed.
5. Carefully reassemble the fuse, end contact and flange. Do not
overtighten the flange (clockwise).
Care and Maintenance
STORAGE
1. Ideal storage temperature range is 0-35°C (32-104°F).
2. Store and use the inverter in a cool, dry place with adequate
ventilation for all-around air circulation.
3. Avoid locations that are exposed to heating units, radiators, direct
sunlight, or excessive humidity or dampness.
Troubleshooting
Specific AC Outlet Problems
When the 120V AC Outlets are in use, the unit will monitor for the
following fault conditions: thermal fault, low battery voltage fault,
overload and short circuit (refer to the "Protective Features" section).
Problem
If a fault condition exists in
either of the AC Outlets,
the LCD will display the
fault condition and the
AC Outlets and the USB
Ports will automatically
shut down. Should this
occur:
21
Possible Solution
A. Disconnect all appliances from
the unit and and hold the power
button for one second again to
turn off the unit immediately.
B. Allow the unit to cool down for
several minutes.
C. Make sure the combined rating
of all appliance simultaneously
plugged into the inverter does not
exceed the maximum output rating
depending on the input source
connected.
D. The voltage of the DeWALT®
20V Battery Pack may be low.
Recharge if necessary.
E. The DeWALT® 20V Battery Pack
may be overheated or is too cold.
Allow the Battery Pack to cool
down or warm up for several
minutes.
F. Make sure the appliance cord(s)
and plug(s) are not damaged.
G. Assure there is adequate
ventilation around the unit before
proceeding.
Publicidad
