Publicidad
Idiomas disponibles
Idiomas disponibles
Connecting the EGC box
Integration of the filter system into the EGC network is optional and not necessary for operation.
(→ Easy Garden Control-System (EGC))
The Connection Cable EGC cable is required for connecting the EGC box.
The correct fastening of the plug connector is important for a secure connection and an interference-
free EGC network.
How to proceed:
1. Remove the protection cap from the unit.
2. Fit the plug connector and secure it with the two screws (max. 18 lb-in (2.0 Nm)).
– Ensure that the rubber seal is clean and fits exactly.
– Replace the rubber seal if damaged.
3. Remove the protection cap from EGC-OUT of the last unit in the EGC network, fit the terminal re-
sistor EGC and secure it with the two screws (max. 18 lb-in (2.0 Nm)).
– Ensure that the terminal resistor EGC rather than the EGC connection cable is connected to
EGC-OUT on the last unit in the EGC network to ensure that the EGC network is closed off
properly.
– The scope of delivery of InScenio EGC Controller contains a terminal resistor EGC.
EGC0031
EGC0003
21
Publicidad
