Publicidad
Idiomas disponibles
Idiomas disponibles
en-us_main.book.book Page 81 Friday, April 26, 2024 11:05 AM
NOTE
• The Rinsing function must be completed even if
the Descaling function is canceled.
• If water remains on the oven bottom after
descaling, it can leave a residue after the oven is
used. To remove the residue, see the
instructions under "Cleaning Scale on Oven
Bottom."
• After running the Descaling function, clean the
steam feeder tank.
Drying the Oven Interior (Upper
Oven Only)
The Drying function removes residual water inside
the steam generator. The function takes a little
over 1 minute and runs automatically after any
steam cooking cycle. The Drying function can also
be started manually, if needed.
Setting Drying
1
Make sure that the steam feeder tank is
empty.
2
Press UPPER OVEN and press CLEANING in
the cooking mode screen.
3
Press Steam Maintenance and press Drying.
4
Press START to begin Drying. The remaining
time appears in the display.
Using Evaporation Function
Use the Evaporation function to dry the oven cavity
after a steam cooking cycle. Evaporation runs for
12 minutes.
Setting Evaporation
1
Press UPPER OVEN or LOWER OVEN and
press CLEANING in the cooking mode screen.
2
Press Steam Maintenance and press
Evaporation.
3
Press START to begin Evaporation. The
remaining time appears in the display.
Periodic Maintenance
Changing the Oven Light
The oven light is a standard 25-watt halogen bulb
for ovens.
WARNING
• Make sure that the oven and bulb are cool.
• Disconnect the electrical power to the appliance
at the main fuse or circuit breaker panel. Failure
to do so can result in severe personal injury,
death, or electrical shock.
• Wear gloves while changing the oven light. Glass
fragments from broken bulbs can cause risk of
injury.
• Gently twist the screwdriver blade while
changing the oven light. If you apply force, the
glass or oven may crack.
1
Unplug the oven or disconnect power.
2
Remove the oven racks.
3
Slide a flat blade screwdriver
housing and the glass light cover
4
Support the glass light cover with two fingers
to prevent the cover from falling to the
bottom of the oven.
5
Gently twist the screwdriver blade to loosen
the glass light cover
c
MAINTENANCE
81
between the
a
.
b
.
Publicidad
